Cold Mold 2 part Compound - 1 pound total purchase weight.

About Cold Mold Kit

Now you can make a rubber mold for casting pewter or other low melt alloys without heat and without mixing and pouring liquids.

This 0% shrinkage silicone rubber is a 2-part putty that you simply knead together and then press into a standard mold frame to cure under pressure, without heat for 30 minutes. Packaged in two containers, part A and part B, weighing a total of 1.3 lbs.

• Working Time:  2 min. (approx)
• Cure Time:  30 min. (approx)
• Durometer:  35
• Shrinkage:  0%
• Tensile Strength:  400 psi
• Tear Strength:  55 ppi
• Elongation:  375%

You get 1- Packaged in two containers, part A and part B Cold Mix 

The 2 pounds indicated is for shipping weight.

 You will receive 1 pound of Cold Mold.

DIRECTIONS